Installation Manual
Stationary Trailer Refrigeration Unit
71.01.121 / 00
Page
33
Copyright by GOVI GmbH 2013. The reproduction of this document or any part there of is prohibited! The right is reserved to make technical changes in the course of further development!
6.
Make sure that the PU seal (2) and/or the fan cover (4) do not become dam-
aged when inserting the unit.
7.
Fasten the refrigeration unit using mounting bolts, washers and self locking
nuts (1) for each of the four holes.
8.
Tighten all four mounting bolts and self locking nuts (1) securely by turning
them clockwise with a wrench.
9.
Replace eye bolts at the top of the refrigeration unit by the plastic threaded
bolts
6.7 Sealing from inside the trailer and laying of drain hose
A
Seal with silicone
Fig. 6-8 Sealing the refrigeration unit
1.
Seal the gap between front wall of the carrier and refrigeration unit from inside
the trailer using silicone.
2.
Make sure that the drain hose is not kinked or damaged and position it so that
it is routed with a fall.
NOTICE
Never cut the drain hose for that will damage the heating of the drain hose and
lead to malfunction of the refrigeration unit.
501 N. Grandview Avenue #135
Daytona Beach, FL 32118
Email: sales@govitrailerrefrigeration.com
Inc.
govitrailerrefrigeration.com
GOVI Inc.
Inc.
GOVI Inc. (USA)
GOVI GmbH (Germany)
To Next Page
Loading...