Installation Manual
Stationary Trailer Refrigeration Unit
71.01.121 / 00
Page
37
Copyright by GOVI GmbH 2013. The reproduction of this document or any part there of is prohibited! The right is reserved to make technical changes in the course of further development!
1.
Make sure that the supply voltage and frequency corresponds to the nominal
values specified on the nameplate and that an applicable wiring is used, see
chapter 4 Technical Data.
2.
Disassemble power plug (1).
3.
Connect wiring to the inner part of the power plug (1) as shown in Fig. 6-9.
4.
Fix wire at the inner part of the power plug (1) using one screw (2) for each
wire.
5.
Insert inner part of the power plug (1) so that both screws (3) match the bores
(4).
6.
Fasten inner part of the power plug (1) at the power plug (1) using the two
screws (3).
7.
Assemble power plug (1) completely and connect power plug (1) to the sock-
et (5) at the refrigeration unit.
501 N. Grandview Avenue #135
Daytona Beach, FL 32118
Email: sales@govitrailerrefrigeration.com
Inc.
govitrailerrefrigeration.com
GOVI Inc.
Inc.
GOVI Inc. (USA)
GOVI GmbH (Germany)
To Next Page
Loading...