Remark : Saving energy when the unit has no sound output on turntable player mode, CD
mode and USB mode about 30 minutes, it will be switched to stand-by automatically. It can be
switched ON the unit by switching the button again.
ACTIVATING THE REMOTE CONTROL
Remove the plastic insulator tag sticking out of the Battery Compartment of the Remote
Control by pulling on it. Once the tag is removed, the Remote Control will be ready for use.
BATTERY CARE
i. If the unit is not to be used for an extended period of time, remove the battery. An old or
leaking battery can cause damage to the Remote Control.
ii. Do not dispose of batteries in fire, batteries may explode or leak.
BATTERY REPLACEMENT
When the battery becomes weak, the operating distance of the
Remote Control is greatly reduced and you will need to replace the
Lithium battery.
1. Remove the battery compartment from bottom of the Remote
Control.
2. Install 1 “CR2025” Lithium battery with the positive side facing up.
3. Replace the battery compartment.
IMPORTANT: Be sure that the battery is installed correctly. Wrong polarity may damage the
Remote Control and void the warranty.
FM RADIO OPERATION
1. Press the FUNCTION Selector (21) to the “TUNER” position. Only FM Radio.
2. Press the TUNING SKIP + or - (16,17) until you reach the radio station you wish to
listen to. The radio FM station frequency shows on the LCD DISPLAY.
3. Adjust the sound level by press the VOLUME CONTROL (18,19).
4. To turn off the radio, Press the ON/STANDBY (22) key once to turn the unit “OFF”.
The LCD DISPLAY will go “off”.
FM STEREO RECEPTION
The FM Stereo Indicator “ ” will light up when listening to a strong station that is
broadcasting in “Stereo”.
TIPS FOR BEST RECEPTION
FM – During FM reception, always keep the FM Wire Antenna fully extended. If FM
reception is weak try repositioning the FM Wire Antenna until you find the strongest
FM signal.
MUSIC EQUALIZER OPERATION
To Next Page
Loading...
