6
Turn on the unit outdoors by pressing the “on/off” button until the indicator is on.
For first use, please initialize the unit and restore it to default setting. (Please refer to 5.4 for
instruction.)
In 10 or 40 seconds, the unit will begin to work and acquire the GSM signals as well as the
GPS signals. The indicator will keep flashing every 3 seconds when the unit has received
the signals.
When this unit receives GPS signals normally, you can use it and do any setting as the
instructions of this manual.
5.4 Initialization
Send “begin+password” in SMS to the unit, it will reply “begin ok” and initialize all the
settings. (Default password: 123456)
For example, send SMS“ begin123456” to the tracker via a cell phone, If succeeded,
if will reply“begin ok”.
5.5 Change the password
5.5.1 Set Password: Send sms: “password+old password+space+new password” to the unit to
change the password.
For Example, pls send sms: “ password123456 888888” to terminal device, it will reply sms:
“password OK”. New password 888888 changed in success.
5.5.2 Be sure keep the new password in mind, you have to upload the software to restore the
original setting in case of losing the new password.
5.5.3 Make sure the new password is in 6 digits Arabic numbers, or the tracker can not
recognize the password.
5.5.4 Make sure that all the symbol“+”in sms commends is just for quick understanding, which
To Next Page
Loading...
