Need help?Do you have a question about the GPS Tracker TK102 and is the answer not in the manual?
General| Weight | 50g |
|---|---|
| Network | GSM/GPRS |
| Band | 850/900/1800/1900Mhz |
| GPS Chip | SIRF3 chip |
| GPS Sensitivity | -159dBm |
| GPS Accuracy | 5m |
| Standby Time | 80 hours |
| Time To First Fix | Cold status 45s, Warm status 35s, Hot status 1s |
| Storage Temp. | -40°C to +85°C |
| Operation Temp. | -20°C to +55°C |
| Humidity | 5%--95% non-condensing |
| SOS Button | Yes |
| Geo-fence | Yes |
| Tracking Modes | SMS, GPRS |
| Waterproof | No |
| Battery | 3.7V Li-ion battery |
| Dimensions | 46mm(L) x 64mm(W) x 17mm(H) |
| Operating Time | Up to 48 hours (depending on usage and network conditions) |
Describes the front view of the TK102 unit.
Describes the rear view of the TK102 unit.
Describes the side view of the TK102 unit, highlighting ports and buttons.
Describes the bottom view of the TK102 unit, showing antenna and microphone.
Shows the internal components like SIM card slot and backup battery.
Details the components included with the TK102 unit.
Explains the meaning of LED indicators and button actions.
Provides step-by-step instructions for installing the SIM card and battery.
Covers fundamental SMS commands like position reporting and timed reports.
How to get the current location of the TK102 via SMS or call.
Command to set the frequency for automatic location reports.
Command to disable automatic timed location reports.
Instructions for configuring GPRS settings via SMS.
Command to set a unique ID for the TK102 tracker.
Command to configure the Access Point Name (APN) for GPRS.
Command to set the IP address and port for GPRS tracking.
Command to set the interval for sending GPRS data packets.
Command to enable or disable the GPRS tracking function.
Addresses issues where the unit fails to power on.
Solutions for when the TK102 does not reply to SMS commands.
Explains the cause and resolution for receiving specific SMS messages.
Command to retrieve the current location of the TK102.
Command to change the user's password for the device.
Command to configure the interval for automatic location reporting.
Command to set phone numbers for SOS alerts.
Command to set thresholds for low battery alerts.
Command to configure speed limits for alerts.
Command to set up geographic boundaries for alerts.
Advanced settings for SMS reports, data format, and device behavior.
Command to set a unique ID for the TK102 tracker.
Command to configure the Access Point Name (APN) for GPRS.
Command to set the IP address and port for GPRS tracking.
Command to enable or disable the GPRS tracking function.
Command to set the interval for sending GPRS data packets.
Command to set the interval for sending GPRS data packets based on distance.
Command to enable power saving mode based on device inactivity.
Command to set a phone number for listening in on the device.
Command to configure the interval for logging location data.
Command to set the device's time zone offset from GMT.
Command to customize the character set for SOS alert messages.
Command to receive SMS reports with a Google Maps link.
To Next Page
