- 8 -
7.2 GPRS Settings by SMS
Tracking via GPRS, you should set IP, Port and APN for TK102.
Ensure that your SIM card in TK102 supports GPRS connection prior to setting.
7.2.1 Set ID for TK102
Command: W<password>,010,ID
Note: Tracker ID must not over 14 digits.
Example: W000000,010,123456789
TK102 will then reply with an SMS (‘Set SIM Ok/123456789’) to confirm this setting.
7.2.2 Set APN
Command: W<password>,011,APN,APN Name,APN Password
Note: If no APN name and password required, input APN only.
Example: W000000,011,CMNET
TK102 will reply with an SMS (like ‘Set APN Ok/CMNET’) to confirm this setting.
7.2.3 Set IP Address and Port
Command: W<password>,012,IP,PORT
Example: W000000,012,202.116.11.12,8000
TK102 will then reply an SMS (‘Set IP Ok /202.116.11.12,8000’) to confirm this setting.
7.2.4 Set Time Interval for Sending GPRS Packet
Command: W<password>,014,time interval(in unit of 10 seconds)
Example: W000000,014,00003
TK102 will send GPRS packet every 30 seconds
7.2.5 Enable GPRS Tracking Function
Command: W<password>,013,X
X=0, to turn off GPRS tracking function (default);
X=1, to set TCP
X=2, to set UDP
Example: W000000,013,1
TK102 will reply with an SMS to confirm this setting.
For more information regarding of bulk configuration by USB cable please refer to < GPS Tracker Parameter
Editor>.
For more information regarding GPRS settings please refer to <GPRS Communication Protocol >.
To Next Page
Loading...
