Grace m902 - Infrared Remote Commands

grace design m902
owner’s manual
18
INFRARED REMOTE COMMANDS
The m902 infrared remote control uses a 32-bit command set. It operates at 38kHz. In addition to
the single press commands, several m902 RCU commands make use of the press hold feature. The
following table lists the implemented command set.
RCU ACTION DESCRIPTION COMMAND REPEATED HOLD
COMMAND
MUTE Press & Release Toggles MUTE state of selected
output
0x02FDD827 -
MUTE Press & Hold Toggles EXCLUSIVE OUTPUT mode
setting
0x02FDD827 0x000000BB
CROSSFEED Press & Release Toggles CROSSFEED mode setting 0x02FD08F7 -
PHONES / LINE Press & Release Toggles selected m902 OUTPUT 0x02FD58A7 -
PHONES / LINE Press & Hold Toggles DISPLAY DIM mode
setting
0x02FD58A7 0x000000BB
BALANCE Press & Release Toggles in and out of BALANCE
adjust mode
0x02FD7887 -
VOLUME UP Press & Release Increments VOLUME or BALANCE
UP
0x02FDE01F -
VOLUME UP Press & HOLD Continuously increments VOLUME
or BALANCE UP
0x02FDE01F 0x000000BB
VOLUME DOWN Press & Release Increments VOLUME or BALANCE
DOWN
0x02FD906F -
VOLUME DOWN Press & HOLD Continuously increments VOLUME
or BALANCE DOWN
0x02FD906F 0x000000BB