Cleanup
20 332919C
9. Raise siphon tube above flushing fluid and run
sprayer for 15 to 30 seconds to drain fluid. Turn
pump switch and engine OFF
10. Turn prime valve down DRAIN position.
11. Remove filters from gun and sprayer, if installed.
Clean and inspect. Install filters.
12. If flushing with water, flush again with mineral spirits,
or Pump Armor, to leave a protective coating to pre-
vent freezing or corrosion.
13. Wipe sprayer, hose and gun with a rag soaked in
water or mineral spirits.
ti22731a
ti14842a
ti15018a
ti2776a
To Next Page
Loading...
