Cleanup
3A4433B 19
4. You can either dispose of the used
FlexLiner and install a new FlexLiner or
clean a used FlexLiner.
5. To clean the sprayer, fill FlexLiner
approximately half-full with appropriate
cleaning fluid (warm water or mineral
spirits).
6. Securely tighten cup support with
FlexLiner to cup cover/prayer.
7. To clean the cup cover and pump filter
and shake the entire sprayer for ten
seconds.
8. Make certain the Prime Pump/Spray
knob is in the Prime Pump position
(pointed down). Set speed control to 10.
9. Turn the sprayer upside down and point
the sprayer into a waste pail. Pull the
trigger for 15 seconds.
ti29760b
ti29766a
To Next Page
Loading...
