3084918
Installation/Operation
How to Flush the Gun
WARNING
To reduce the risk of serious injury, including
splashing fluid in the eyes or on the skin, or static
electric discharge when flushing:
D Be sure the entire system, including flushing
pails, are properly grounded.
D Remove the tip guard and spray tip.
D Maintain metal to metal contact between the
gun and the flushing pail.
D Use the lowest possible pressure.
04735
Always flush the pump and gun before the fluid being
sprayed can dry in it.
NOTE: This procedure requires a grounded pail of
compatible solvent.
1. Relieve pressure.
2. Remove the tip guard and spray tip. Soak and
clean the parts.
3. Remove the pump intake from the original pail.
4. Put the pump intake in a grounded pail of compat-
ible solvent.
5. Start the pump at its lowest pressure.
6. T rigger the gun into the original pail. When solvent
appears, release the trigger.
7. Now trigger the gun into the solvent pail. Circulate
the fluid until the system is thoroughly flushed.
8. Relieve pressure.
To Next Page
Loading...
