Warnings
4
CAUTION
Water or material remaining in unit when temperatures are below freezing can damage
motor and/or delay pump startup. To insure water and material are completely drained out
of unit:
1. Remove material line from sprayer.
2. Tip sprayer up as shown.
Before adding material or starting unit in cold weather, run warm water through pump.
Install burp the guard (J) before adding material to the hopper. When only a small amount of
material remains in the hopper, the burp guard prevents material from shooting out when
the unit is turned off. This material could splash into the operator’s eye or skin.
ti8713a
ti8697a
J
To Next Page
Loading...
Need help?
General
