EasyManua.ls Logo

Graco Reactor H-25 Series User Manual

Graco Reactor H-25 Series
38 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Page #1 background imageLoading...
Page #1 background image
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2007, Graco Inc. is registered to I.S. EN ISO 9001
312062 rev. A
Operation
Hydraulic, Heated, Plural Component Proportioner
For spraying polyurethane foam and polyurea coatings.
Not for use in explosive atmospheres.
See page 3 for model information, including
maximum working pressure and approvals.
Important Safety Instructions
Read all warnings and instructions in this manual.
Save these instructions.
T9830a
Model H-40 Shown

Other manuals for Graco Reactor H-25 Series

Question and Answer IconNeed help?

Do you have a question about the Graco Reactor H-25 Series and is the answer not in the manual?

Graco Reactor H-25 Series Specifications

General IconGeneral
BrandGraco
ModelReactor H-25 Series
CategoryPaint Sprayer
LanguageEnglish

Summary

Operation and Safety Instructions

Important Safety Instructions

Key safety guidelines to read before operating the equipment.

General Warnings

Electric Shock Hazard

Precautions against electric shock due to improper grounding or usage.

Toxic Fluid or Fumes Hazard

Risks from toxic fluids/fumes, requiring specific PPE and handling.

Skin Injection Hazard

Dangers of high-pressure fluid injection and immediate treatment requirements.

Additional Warnings

Fire and Explosion Hazard

Prevention of fire and explosion from flammable fumes and static electricity.

Equipment Misuse Hazard

Dangers of operating the equipment improperly, including fatigue or intoxication.

Moving Parts Hazard

Risks of injury from moving parts, requiring clearance and guards.

Burn Hazard

Precautions against burns from hot equipment surfaces and fluids.

Isocyanate Handling and Hazards

Material Self-ignition

Risks of materials igniting when applied too thickly.

Moisture Sensitivity of Isocyanates

How isocyanates react with moisture, causing crystal formation and gelling.

Component A and B Separation

Warning to prevent cross-contamination by not interchanging A and B components.

Component Identification and Labels

Temperature Control Panel Overview

Temperature Adjustment and Zone Control

Circuit Breaker Identification

Motor Control Panel Overview

Hydraulic Pressure Adjustment

Spray Adjustment Factors

Equipment Setup Procedures

Startup Procedures

Spraying Operation Guide

Pressure Relief Procedure

Fluid Circulation Procedures

Diagnostic Codes and Error Identification

Maintenance Procedures

Fluid Inlet Strainer Maintenance

Pump Lubrication System Setup

Flushing Procedures

Related product manuals