Grounding and Electrical Requirements
309477F 7
Grounding and Electrical Requirements
This sprayer requires 220-240 VAC, 50/60 Hz, 10A
circuit with a grounding receptacle. Do not use an outlet
that is not grounded.
Do not use the sprayer if the electrical cord has a
damaged ground prong. Only use an extension cord
with an undamaged 3-prong plug.
Only use an extension cord with an undamaged 3-prong
plug. Recommended extension cords for use with this
sprayer are:
• 15 m (49.2 ft) 1.0 mm
2
• 30 m (88.4 ft) 1.5 mm
2
• 50 m (164.0 ft) 2.5 mm
2
Spray gun: ground through connection to a properly
grounded fluid hose and pump.
Fluid supply container: follow local code.
Solvent pails used when flushing: follow local code.
Use only conductive metal pails, placed on a grounded
surface such as concrete. Do not place the pail on a
nonconductive surface, such as paper or cardboard,
which interrupts grounding continuity.
Grounding the metal pail: connect a ground wire to the
pail by clamping one end to pail and other end to ground
such as a water pipe.
To maintain grounding continuity when flushing or
relieving pressure: hold metal part of the spray gun
firmly to the side of a grounded metal pail, then trigger
the gun.
Thermal Overload
Motor has a thermal overload switch to shut itself down
if overheated.
Smaller-gauge or longer extension cords may
reduce sprayer performance.
ti2021a
ti2022a
WARNING
To reduce risk of injury from motor starting unex-
pectedly when it cools, always turn power switch
OFF if motor shuts down.
To Next Page
Loading...
