To Next PageTo Next PageWhy won't the flow adjustment adjust on my Graco Magnum TexFinish 246186?
If the flow adjustment on your Graco Paint Sprayer won't adjust, consider these causes: * Dirty threads. Solution: Clean the threads. * No nozzle on the gun. Solution: Put the nozzle on the gun.
General| Model | 246186 |
|---|---|
| Type | Airless Paint Sprayer |
| Max Pressure | 3000 PSI |
| Hose Length | 25 ft |
| Power Source | Electric |
| Voltage | 120V |
| Amperage | 15 A |
| Maximum Hose Length | 100 feet |
| Pressure Control | Adjustable |
| Tip Size | 0.015 - 0.019 inches |
Improper grounding, poor ventilation, open flames or sparks can cause a hazardous condition and result in fire or explosion and serious injury.
Equipment misuse can cause equipment to rupture, malfunction, or start unexpectedly and cause serious injury.
To reduce the risk of electric shock, be sure sprayer is adequately grounded, use only 3-wire extension cords, and ensure ground prongs are intact.
Fluid from gun, leaks or ruptured components can splash in the eyes or on skin and cause serious injury. Follow Pressure Relief Procedure.
Use only compatible water-based solvents to clean plastic parts, as many solvents can degrade plastic, causing failure and injury.
Follow this procedure to reduce risk of injury whenever stopping spraying, checking, or repairing the system.
Ensures proper grounding to reduce risk of electrical shock. Use appropriate outlets and extension cords.
Guidelines for selecting appropriate extension cords based on length and gauge for safe operation.
Instructions for connecting air and material hoses, filling the hopper, and setting the selector switch.
Steps for attaching the hopper to the sprayer, including hose connections and nozzle installation.
Instructions for operating the sprayer in hopper gun mode, including air valve and power switch settings.
Instructions for mixing dry texture material with water, including agitation and consistency checks.
Guidance on mixing premixed texture material with water to achieve the correct consistency.
Chart detailing nozzle sizes and air volumes for different spray applications like acoustic and spatter coat.
Tips for balancing fluid output, atomization, material flow, and nozzle selection for desired results.
Techniques to prevent material surge at the gun trigger when starting or stopping spray.
Procedure for cleaning the material hopper, gun, and hose after use with water.
Step-by-step guide on how to safely remove the material hopper from the sprayer for cleaning or storage.
Instructions on how to remove the handle and hopper for easier storage or transportation of the unit.
Common problems like sprayer not running or pump not pumping material, with causes and solutions.
Troubleshooting for issues related to air flow from the compressor, such as low air or plugged gun.
Solutions for slow application speed, sputtering, or leaks at adjustment points.
