Reactor Error Code Trouble Shooting Guide
Rev 2.6 (02/2014) Page 34
E25: High Line Voltage (Return to Table Of Contents)
Cause:
1) Supply voltage too high.
Check voltage requirements in technical data section of the manual.
Verify input voltage is correct to motor control board for your system.
E26: Low Line Voltage
(Return to Table Of Contents)
Cause:
1) Supply voltage too low.
Check voltage requirements in technical data section of the manual.
Verify voltage is correct to the motor control board for your system.
The E-30 and E-XP2 Reactors have a filter between the pump circuit breaker and
connection L & N on control board.
To Next Page
Loading...
