Pressure Relief Procedure
334641E 9
Pressure Relief Procedure
Follow the Pressure Relief
Procedure whenever you see this
symbol.
1. Turn ON/OFF switch to the OFF
position.
2. Engage the trigger lock.
3. Turn pressure control to the lowest
setting. Disengage the trigger lock.
4. Hold a metal part of the gun firmly to a
grounded metal pail. Trigger the gun to
relieve pressure.
5. Engage the trigger lock.
6. Turn the prime valve down. Put drain
tube in a pail. Leave prime valve in the
down (drain) position until you are ready
to spray again.
7. If you suspect the spray tip or hose is
clogged or that pressure has not been
fully relieved:
This equipment stays pressurized until
pressure is manually relieved. To help
prevent serious injury from pressurized
fluid, such as skin injection, splashed fluid
and moving parts, follow the Pressure
Relief Procedure whenever sprayer is
stopped and before sprayer is cleaned or
checked, and before equipment is
serviced.
To Next Page
Loading...
