Graco T-MAX 506 Quick Operator's Guide

T-MAX
™
506/657
www.graco.com
START-UP
STAR-TUP
Spray WITH Air <= 1.5 mm
Fill product hopper
with pre-mixed texture
product.
Turn pressure control
knob until steady stream
flows from product tube.
Turn pump OFF.
Turn applicator OFF.
Turn ON/OFF switch
to ON.
Loosen nut on bottom
of pump
2-3 turns to
release pressure.
Turn pressure control to
maximum. To spray, aim
applicator at wall from
0.5 m distance wall and
open applicator.
To clean clogged tip, turn
applicator OFF, turn tip 180° to
CLEAN position, aim towards free
area, turn applicator ON. When
clog clears, turn applicator OFF
and tip to SPRAY postion.
Turn pressure
control off (0).
Aim applicator into
hopper.
Turn applicator ON.
2
DO NOT USE WITH
QUICK-SET MATERIALS
Pressure Relief
2
DO NOT USE WITH
QUICK-SET MATERIALS
Pressure
Relief
Use different
tip nozzle size
to adjust flow.
Install filter and tip
extension.
Connect applicator
to product tube.
Add water if thinning is
required. Mix thoroughly.
HDA531
HDA535
HDA541
HDA545
HDA651
HDA661
HDA671
mc 03
m
c
52
Spray WITHOUT Air < .25 mm
Screw tip assembly
onto applicator.
Fill product hopper with
mixed texture product.
Place product tube into hopper, turn ON/OFF switch to ON.
Turn control knob to ‘green’ section and allow material to product 30 sec.
Turn pump control knob to
shut pump off.
Screw air hose and valve to applicator.
Connect product tube to gun.
Turn applicator valve OFF.
Insert air nozzle.
Hold applicator over
product hopper and turn
applicator ON.
Turn air compressor ON. Turn pump
control knob to ‘green’ section to
achieve desired product flow rate.
Regulate air valve for
proper atomization.
To stop spraying,
turn applicator OFF.
Quick Operator’s Guide
SET-UP
This procedure is for water-based paints and flushing agents. For solvent-based paints and flushing agents (i.e. mineral spirits), you must first
read the section on Fire and Explosion Hazards in the Operating Instructions. Please note this Quick Guide is at no means replacing the official
Graco manual. Graco can at no means be liable for any consequences of not following the safety regulations as stipulated in the official manual.
* Please check the Graco operations manual supplied with the unit for more details.
WARNING
Turn pump control off (0).
Plug electrical cord into grounded outlet.Connect pump module to hopper cart.
Remove pump plug.
Connect product tube to pump outlet.
PRESSURE RELEASE PROCESS

Graco T-MAX 506 Specifications

General

Brand	Graco
Model	T-MAX 506
Category	Paint Sprayer
Language	English