Turn pump control knob counter-clockwise,
to shut off pump.
Close applicator after pressure release.
Close air valve.
Scrape remaining product in
hopper into pump to be pumped
from sprayer.
Rotate pump control to
(0) to shut pump off.
Shut air compressor OFF if spraying with air.
Remove applicator from product tube.
Clean applicator.
Turn pump control
clockwise to start pump.
Turn pump control to (0) to
shut pump OFF.
Clean applicator, spray tips and
guard with brush.Set ON/OFF switch to OFF.
Turn pump control
clockwise to pump
unused texture product
out of product hopper
and tube.
Run pump until
cleaning ball exits
product hose.
Retrieve cleaning
ball. Repeat till water
comes out clear.
Insert moistened cleaning ball into pump.
Connect product tube to pump outlet.
Clean hardened product
from applicator nozzles
with air nozzle cleaner.
Remove drain plug from hopper.
Clean hopper with water, brush
and sponge. Insert drain plug.
Fill hopper with 1/3clear water.
GRACO DISTRIBUTION BVBA Industrieterrein Oude Bunders
Slakweidestraat 31 • B-3630 Maasmechelen
Tel: +32 (89) 770 700 • Fax: +32 (89) 770 777
www.graco.com
© 2018 GRACO DISTRIBUTION BVBA · Form No. 328033ENEU (revD)· 08/18 · Digital version only.
Graco is certified ISO 9001.
All information, illustrations, and specifications in this document are based on the latest product information available at the time of publication.
The right is reserved to make changes at any time without notice. For more information on Graco’s intellectual property, see www.graco.com/patent or www.graco.com/trademarks.
CHOOSE THE RIGHT TIP (HDA-XXX)
CLEAN-UP
XTRA LIGHT LIGHT MEDIUM HEAVY
HDA531 HDA541 HDA651 HDA671
HDA535 HDA545 HDA661 -
VERY FINE - 3 MM FINE - 4 MM MEDIUM - 6 MM MEDIUM HEAVY - 8 MM HEAVY - 10 MM
248888 248524 248525 248526 248527
To Previous Page
Loading...
Need help?
General
