Flush the Equipment (Solvent-Based Materials)
312879E 5
Flush the Equipment
(Solvent-Based Materials)
• Flush before changing materials, before fluid can
dry or cure in the equipment, at the end of the day,
before storing, and before repairing equipment.
• Flush with a fluid that is compatible with the fluid
being dispensed and the equipment wetted parts.
• Flush at the lowest pressure possible. Check con-
nectors for leaks and tighten as necessary.
• Do not leave the applicator or any parts in water or
cleaning solvents.
1. Follow Pressure Relief Procedure, page 4.
2. Remove the spray tip and guard by loosening
retaining ring (10).
3. Hold a metal part of the gun firmly to a grounded
metal pail. Trigger the gun until clean solvent
dispenses.
4. Store in a dry location.
To avoid fire and explosion, always ground equipment
and waste container. To avoid static sparking and
injury from splashing, always flush at the lowest
possible pressure.
To Next Page
Loading...
Need help?
General
