Graco TexSpray RTX 750 - Page 6

Setup
6 309585A
Setup
Texture Spraying (6-8 gallon material
hopper)
1. Connect air hose and
material hose to
sprayer air and mate-
rial hose outlets.
2. Connect air hose to
gun.
3. Open air valve.
4. Connect material hose
to gun.
5. Install spray nozzle.
See Recommended
Nozzle Selection Chart,
Page 10.
6. Fill material hopper
with 1 gallon of water.
7. Turn hopper gun/spray
gun selector switch to
SPRAY GUN.
Important
• If you are going to stop spraying for more than 5 minutes, turn sprayer off to prevent shortened pump hose life.
• Do not allow material to dry inside pump, hoses, gun or spray system.
WARNING
page 2.
• When using
material hopper,
insert the Gun
Plug in the top of
the gun. Make
sure both plug
tabs are securely
snapped into
place. Hose plug
must be removed
from bottom of
gun.
ti3163a
ti2449
ti2448a
ti2450
ti2451
ti2452
ti2456