Setup
309585A 7
8. Turn power switch ON.
9. Close gun air valve.
10. Point gun into waste bucket and pull trigger to pump
water through the system. Continue to trigger gun
until material hopper is empty.
11. Install burp guard. Caution,
page 3.
12. Add pre-mixed texture mix to material hopper. See
Mixing Material, page 9.
13. Continue to trigger gun and spray into waste bucket
until a steady stream of material sprays out of gun.
14. Release trigger. To
achieve uniform
spray pattern, adjust
air valve and flow
adjustment nut on
gun. If you do not
achieve the desired
pattern, change nozzles, page 10.
15. For RTX 1000 model: when using a thicker texture:
• Turn material flow
control knob clockwise
to increase material
flow.
• If you want more
control when spraying
splatter or orange peel,
turn the control knob
counter-clockwise to
decrease material flow.
Touch Up Hopper Attachment
1. Connect air hose to sprayer.
2. Connect air hose to gun.
3. Clip material hose to
air hose.
4. Slide hopper on top of
gun, and tighten clamp.
5. Install spray nozzle.
Page 10.
6. Fill Touch-up hop-
per with pre-mixed
texture. See Mixing
Material, page 9.
• Fluid flow will be restricted if the material hose
is kinked.
ti2446
ti2453
ti2894a
I2698a
ti2489a
• The Hose Plug
must be securely
fastened to bottom
of gun when using
the Touch Up
Hopper. Gun plug
must be removed
from top of gun.
ti2699
ti2721a
ti2561a
ti2559
To Next Page
Loading...
