What to do if the pump is frozen or paint hardened in my Graco Ultimate Nova 395?
If you're having basic mechanical problems with your Graco Paint Sprayer, such as a pump frozen or paint hardened in the pump, thaw the sprayer if water or water-based paint has frozen inside by placing it in a warm area until completely thawed. Do not start the sprayer until it is fully thawed. If paint has hardened (dried) inside, replace the pump packings.
How to fix loose motor leads on my Graco Ultimate Nova 395 Paint Sprayer?
If you're facing basic electrical problems with your Graco Paint Sprayer's motor leads, replace any loose terminals by crimping them to the leads, ensuring they are firmly connected. Clean the circuit board terminals and securely reconnect the leads.
How to fix the displacement pump connecting rod pin on my Graco Ultimate Nova 395?
If you're dealing with basic mechanical problems on your Graco Paint Sprayer and the displacement pump connecting rod pin isn't fully pushed into the connecting rod, push the pin into place and secure it with the spring retainer.
What to do if my Graco Ultimate Nova 395 Paint Sprayer stops after a few minutes due to a tight pump packing nut?
If your Graco Paint Sprayer quits after operating for 5 to 10 minutes, and you suspect the tightness of the pump packing nut, loosen the packing nut and check for leaking around the throat. Replace the pump packings if necessary.
Overview of electric airless sprayers for architectural paints and coatings.
Crucial safety information and warnings for proper use and handling of the equipment.
Precautions to prevent ignition of flammable fumes and vapors.
Safety measures to avoid electric shock during operation and maintenance.
Risks and procedures related to high-pressure fluid injection injuries.
Risks of using specific solvents with aluminum components.
Dangers of exposure to hazardous fluids and fumes.
Required PPE for safe operation, servicing, and presence in the operating area.
Electrical specifications for 100-120V and 230V units.
Guidelines for selecting and using extension cords with the sprayer.
Proper use and grounding of pails for fluids during operation.
Steps for operating the digital display sprayer, including pressure settings.
Accessing and interpreting stored operational data on the digital display.
Navigating and using the main operational menu of the digital display.
Accessing and using the secondary menu for error codes and software.
How to change pressure units and related volume measurements on the display.
General| Type | Airless Paint Sprayer |
|---|---|
| Max Pressure | 3000 PSI |
| Power Source | Electric |
| Hose Length | 50 ft |
| Maximum Working Pressure | 3000 PSI |
| Maximum Tip Size | 0.021 inches |
| Tip Size | 0.015 - 0.021 inches |
To Next Page