Tip and Guard Assembly
10 309665L
Tip and Guard Assembly
5 Hold gun against grounded
metal flushing pail. Trigger
gun and increase fluid
pressure to 1/2. Flush
1 minute.
Inspect for leaks. Do not stop
leaks with hand or a rag! If leaks
occur, do Pressure Relief. Tighten
fittings. Do Startup, 1. - 5, page 9.
If no leaks, proceed to 6.
6 Place siphon tube in paint pail.
7 Trigger gun again into flushing pail until paint appears. Move gun to
paint pail and trigger for 20 seconds. Set gun safety ON. Assemble
tip and guard, page 10.
1 Insert metal seal and
OneSeal.
2 Insert SwitchTip. 3 Screw assembly onto
gun.
Tighten.
WASTE
ti2599a
PAINT
ti2714a
WASTE
ti2713a
ti2709a
ti2708a
ti2710a
To Next Page
Loading...
