Graco Ultra 395 - Spraying Operation; Clearing Clog

Tip and Guard Assembly
309665L 11
Spraying
Clearing Clog
1 Spray test pattern. Start with pressure turned to its lowest
setting, then gradually increase pressure gradually until
you achieve a consistent spray pattern without heavy
edges. Use smaller tip size if pressure adjustment can not
eliminate heavy edges.
2 Hold gun perpendicular, 10-12 in. from surface. Spray back
and forth, overlapping by 50%. To prevent heavy spots,
before pulling trigger, first move gun using a back and forth
motion. When you stop spraying, after releasing trigger,
continue to move gun back and forth for a few seconds.
heavy
edges
ti2757a
TIB
-
ti2758a
1 a.) Release trigger, put safety ON.
b.) Rotate SwitchTip.
c.) Take safety OFF.
d.) Trigger gun to clear clog. Never point gun at your hand
or into a rag!
2 a.) Put safety ON.
b.) Return Switch to original position.
c.) Take safety OFF and continue spraying.
a.
b.
c.
a .
b.
c.