Graco Ultra 395 - Setup

Setup
8 309665L
Setup
Throughout these instructions, Model 233960 is shown in all illustrations. Your sprayer model may look slightly
different than pictured.
1 Connect Graco airless
hose to sprayer.
Tighten securely.
2 Connect other end of
hose to gun.
3 Tighten securely. 4 Remove tip guard.
TI2597a
ti2702a
ti2703a
ti2769a
5 Check inlet strainer for
clogs and debris.
6 Fill throat packing nut
with TSL to prevent
premature packing wear.
Do this each time you
spray.
7 Turn power OFF. 8 Plug power supply cord
into a properly grounded
electrical outlet.
ti2812a
Approximate Fill Level
ti2707a
ti2810a