To Next PageTo Next PageWhy is the drain valve leaking on my Graco ULTRA R MAX 695 309067 Paint Sprayer?
If the drain valve on your Graco Paint Sprayer leaks, tighten it to 185 in-lb (21 Nm). Clean the valve and replace it with a new gasket and sealant.
How to fix spray pattern variations with my Graco ULTRA R MAX 695 309067 Paint Sprayer?
If your Graco Paint Sprayer is showing spray pattern variations, try replacing the spray tip. Note that a smaller size tip provides longer life. If the issue persists, replace the board.
What to do if the building circuit breaker opens when I plug in my Graco ULTRA R MAX 695 309067?
If the building circuit breaker opens as soon as the Graco Paint Sprayer is plugged into the outlet, but the sprayer is not turned on, replace the ON/OFF switch or any other damaged parts.
What to do if the circuit breaker opens when I turn on my Graco Paint Sprayer?
If the building circuit breaker opens as soon as you turn on the Graco Paint Sprayer switch, repair or replace any damaged wiring or terminals, and securely reconnect all wires. Also, correct any other faulty conditions, replace the motor, or replace the board.
Why is my Graco ULTRA R MAX 695 309067 motor hot and running intermittently?
If your Graco Paint Sprayer motor is hot and runs intermittently, try decreasing the pressure setting or increasing the tip size. You can also move the sprayer to a shaded, cooler area. If the problem persists, consider replacing the motor.
What to do if my Graco ULTRA R MAX 695 309067 motor runs and pump strokes but there is no output?
If your Graco Paint Sprayer has no output, but the motor runs and the pump strokes, try refilling and repriming the pump. Also, remove and clean the components, then reinstall them. Ensure that you tighten all connections, using thread sealant on the npt threads of the adapter fitting. Remove the intake valve and clean it, checking the ball and seat for nicks; replace as needed. Remember to strain the paint before using to remove particles that could clog the pump. Replace the packings, and check the piston valve seat for hardened paint or nicks, replacing if necessary. Tighten the packing nut. If the pump consistently comes to rest with the rod fully extended, the piston packings and/or piston valve may be worn, so service the pump.
What to do if my Graco ULTRA R MAX 695 309067 motor runs but pump does not stroke?
If your Graco Paint Sprayer has no output, and the motor runs but the pump does not stroke, replace the pin if it is missing, ensuring the retainer spring is fully in the groove all around the connecting rod. Also, replace the connecting rod assembly. Check the drive housing assembly for damage and replace if necessary.
Why won't my Graco ULTRA R MAX 695 309067 run on a generator?
If your Graco Paint Sprayer will not run on a generator but does run on AC power, use AC power or a different generator.
General| Power Source | Electric |
|---|---|
| Hose Length | 50 ft |
| Type | Airless |
| Motor Type | Brushless |
| Model | ULTRA R MAX 695 309067 |
Essential safety warnings, tool list, and general repair guidelines.
Steps to safely release system pressure before servicing.
Proper electrical grounding procedures for safe operation.
Systematic troubleshooting for common output and operational issues.
Tests for armature short circuits and continuity.
