Problem Cause Solution
The blade is stiff or the
speed of the blade is greatly
reduced.
The blade gear wheel not
sufficiently greased or dirty.
Remove the blade and
clean the blade gear wheel
thoroughly. Subsequently
grease according to the
instructions.
The unit is overloaded. Interrupt the cutting process
and cautiously remove the
slicing material. Make sure
to use only suitable goods
to be cut and adjust the
cutting width accordingly, if
necessary.
The cable winder cannot be
swivelled in or out.
If the cable is wound up too
loosely, it forms loops that hit
the housing.
Try to unwind the cable
carefully. This is usually
possible even if the cable
winder is still in the unit.
The unit slips on the work top
while cutting.
The installation surface or the
rubber feet of the unit are
soiled.
The installation surface
and the rubber feet of the
machine must be clean and
free of grease.
The blade does not cut well
any more.
The blade is blunt and needs
to be sharpened.
The cut slicing material is
pulled behind the blade.
The slicing material is not
correctly scraped off. The
distance between the blade
and the housing is too large.
Make sure that the blade
is fitted correctly and that
there is no dirt on the inside
of the blade. If necessary,
clean the blade and the
inside of the unit according
to the instructions.
Operating noises increase
with use.
The gear is not greased
sufficiently.
Remove the blade and
clean the blade gear wheel
thoroughly. Then grease
the gear wheel and sliding
cams according to the
instructions.
44
To Next Page
Loading...
