DE
EN
FR
NL
IT
SV
ES
NO
DK
RU
PL
UK
HU
Problem Cause Solution
The blade is loose. The blade screw not locked. Make sure that the blade
is correctly fitted and the
blade screw is firmly locked
= turn anti-clockwise to the
left.
The sliding cams have come
loose.
On the inside of the unit
under the blade there are
three sliding cams. Make
sure that these are in place.
Contact GRAEF Service if
the sliding cams are missing.
The unit continues to run
even though the limit stop is
closed.
The ON/OFF switch was
still in position II for conti-
nuous operation when the
limit stop was closed.
Slide the ON/OFF switch
back to position 0. Make
sure to switch off the unit first
before closing the limit stop.
45
To Next Page
Loading...
