Graham Field HAUSTED EPC Series - Common Optional Accessories; Mounting the Wrist Rest; Adjusting the Wrist Rest; Installing #18 IV Rod

APC-US-INS-LAB-RevC18 19
3.10 COMMON OPTIONAL ACCESSORIES
3.10.1 Mounting the Wrist Rest
Insert the wrist rest into one of the
appropriate three square sockets under the
headrest (Figure 3-31). Rotate the T-knob
on the back of the wrist rest (Figure 3-32)
clockwise to lock it into place.
s NOTICE: Ensure the wrist rest is secure
before applying any pressure.
3.10.2 Adjusting the Wrist Rest
Once the wrist has been properly installed per
3.9.1, the height can be adjusted as needed.
Support the wrist rest and loosen the black
knob on the side of the support post (Figure
3-33).
Position the wrist rest to the desired height
and rotation. Tighten the black knob located
on the side of the support post (Figure 3-33).
s NOTICE: Ensure the wrist rest is secure
before applying any pressure.
3.10.3 Installing #18 IV Rod
Remove the IV Rod from the clips located
on the base (Figure 3-34). Insert IV Rod into
preferred socket (Figure 3-35). Place IV Rod
back into storage clips when not in use (Figure
3-34).
3.10.4 Installing the Side Tray
Insert pin end of Side Tray assembly into
preferred socket on the seat section. Align
hole in pin with hole in seat section socket and
insert locking pin to prevent movement of tray
(Figure 3-36).
FIGURE 3-33
FIGURE 3-34
FIGURE 3-35
FIGURE 3-36
FIGURE 3-31
FIGURE 3-32