765042196 Rev. 000 11
Always disconnect the power if interruptions in power supply occur, and when
electrical parts are removed/put on, and before cleaning and maintenance of the
product.
Do not use the product before all coverings are installed, so that live or rotating
machine parts cannot be touched.
The product is not to be used outdoor.
All earthing requirements stipulated by the local electricity authorities must be
observed. The plug and wall socket should then give correct earthing. If necessary,
contact an electrician.
Make sure the product is switched off at the socket or that the kettle plug
is disconnected, before service is performed on electrical parts. It is not
sufficient to switch off the product at the controller.
General use
Do not damage the refrigeration system parts.
If the product is fitted with a re-evaporation tray underneath the cabinet it is
important not to service/clean the tray or the heater, before the cabinet has been
turned off long enough to make sure that the re-evaporaton heater has cooled
off, in order to prevent the risk of burns.
Do not use electrical devices inside the product.
To ensure correct and efficient air flow in the cabinet, the shaded areas must be
kept free of items. (see Fig. 6)
All items to be stored, that are not wrapped or packed, must be covered in order
to avoid unnecessary corrosion of the inner parts of the cabinet.
If any controller parameters are changed from default, this could cause that the
product is not functioning normally, and harmful temperatures could damage
items that are kept inside the product.
Maximum loading of wire shelf: 40 kg
Do not store explosive substances such as aerosol cans with flammable
propellant in this appliance.
To Next Page
Loading...
