Gram IOS 20644-92 X User Manual

20
OPERATION
P14 Mu󰀩ns 06 160
P15 Cookies 06 150
P16 Fruitcake 12+07 175
P17 Bread 07 180
P18 Dough proving 07 30
P19 Dry 06 50
Note: Do not set the function selector knob
to “0”, i.e o󰀨 position.
All pre-set programmes can be freely modi-
ed – you can adjust temperature or duration.
To do this, follow the relevant instructions
(“Preview and modify settings during oven
operation” and “Timed operation”). When you
make any adjustments, the stored pre-set
programme is not a󰀨ected and the original
settings will be restored the next time you
select a pre-set programme.
Note: To cancel a pre-set programme im-
mediately after you se it with the sensor
you need to rst turn the function selector
knob to the required function and let the ap-
pliance to start the programme, if only for a
few seconds. When the pictogram is show
you can turn the function selector knob to “0”.
If attempt to use a pre-set programme when
the meat probe is plugged in, you will hear a
beep to remind you to unplug the meat probe.
The appliance will start when you unplug the
meat probe and close the oven door.
Pre-set programmes with quick pre-heat
Some pre-set programmes require the oven
to be pre-heated. They are marked accord-
ingly in the above table. When you select
a pre-set programme with pre-heating, the
quick pre-heat pictogram will be displayed.
When the pre-heat temperature is reached
you will hear beeping and the “:07” number
and the pictogram will fash by the pre-set
programme number.Open the door and the
pictogramm will be o󰀨. Place the dish in
the oven and close the door. Turn the func-
tion selector knob to the heating function
corresponding to the ashing number — the
number will be o󰀨 and the appliance will start.
Note: It is inadvisable to modify a pre-set
programme during the quick pre-heat phase
as this will cancel the pre-set programme and
the appliance will operate with the currently
set function, duration and temperature.
End a pre-set programme.
When a pre-set programme ends, you will
hear beeping.
Oven door
Oven door must be closed during operation.
When you open the door you will interrupt
the active oven function. If the door remains
open for more than 30 seconds, an acoustic
signal will sound to prompt you to close the
oven door. Touch any sensor or close the
oven door to mute the beeping.
If you open the door for less than 10 minutes
the active settings are una󰀨ected. For safety
reasons, after this time, the oven enters the
standby mode (all settings are cleared).

Gram IOS 20644-92 X Specifications

General

Brand	Gram
Model	IOS 20644-92 X
Category	Oven
Language	English