11
Electrical connection
The appliance is intended for connection to alternating current.
The connection values for voltage (V) and frequency (Hz) are given
on the nameplate inside the cabinet.
Power must be connected via a wall socket with switch. The wall
socket should be easily accessible.
It is recommended, as with any high tech appliance, that a power
surge protection device be used.
All earthing requirements stipulated by the local electricity
authority must be observed. The cabinet plug and wall socket
should then give correct earthing. If in doubt, contact your local
supplier or an authorised electrician.
WARNING - This appliance must be earthed. The flexible cord
(mains lead) fitted to this appliance has three cores for use with a
3-pin 10 amp plug.
IMPORTANT
The cores in this mains lead are coloured in accordance with the
following code:
GREEN AND YELLOW - EARTH
BLUE - NEUTRAL
BROWN - LIVE
These colours might not correspond with the colour markings
identifying the terminals in your plug.
Proceed as follows:
Connect the GREEN AND YELLOW core to the plug terminal
marked “E” or by an earth symbol, or coloured GREEN or GREEN
AND YELLOW. Connect the BLUE core to the plug terminal
marked “N” or coloured BLACK.
Connect the BROWN core to the plug terminal marked “L” or
coloured RED.
To Next Page
Loading...
Need help?
General
