765041982 Rev. 000 15
Initial defrosting of the evaporator
(connection when the unit is cold)
If the unit is in use and it is cold in the room, the program starts with a defrosting cycle:
In connection with this, the display shows the
temperature internally within the unit.
The defrosting symbol is lit up:
Do not use pointed or sharp objects to make defrosting go faster!
Storage program
(connection when the unit is warm)
If the unit is started in a warm state (normal room temperature internally inside the unit), then
it will immediately switch to the storage program
In connection with this, the display shows the
temperature internally within the unit.
When the storage program has been activated,
only one of the compressors will be working.
The fan will run at a low RPM figure (SF950plus).
Hence only one of the two compressor symbols will
be lit. In addition, the symbol for the evaporator fan
will be displayed.î
To Next Page
Loading...
Need help?
General
