765041982 Rev. 000 18
Time-controlled cooling "HCL"
î
This program is time-controlled only. The air temperature and the
temperature of the contents of the cabinet are not taken into account.
Both compressors perform the cooling in parallel. The second
compressor starts 15 seconds after the first one.
The program is selected by pressing the button
:
When the button is pressed, it will stay lit continuously,
and the
P
,
+
and
-
buttons will blink. The symbol for
the clock will light up. The secondary display will show the
program name "HCL" and the tertiary display the selected
duration in minutes. The symbols for a high fan RPM figure
and operation with 2 compressors will be blinking.
The
+
and
-
buttons are used to change the time, and
P
for starting the program.
While the program is running, the time will count down on
the tertiary display. The primary display will show the current
temperature inside the unit. In addition, the connected
elements will now be continuously lit: both compressors,
both fan symbols.
After the preset period of time expires,
an acoustic signal is emitted.
After the signal, defrosting is
commenced (if such is required based
upon the evaporator sensor's
temperature). Then it subsequently
switches to the storage program.
Hence the desired value for the
storage program must always be set
and checked before starting "HCL"!
To Next Page
Loading...
Need help?
General
