765041982 Rev. 000 21
Thawing program
In connection with thawing, a defrosting heating element is used,
which is governed by the temperature that the room sensor measures.
The thawing program is only able to start when the desired
temperature value is set to between +2C and +8C.
The pro
ram is started b
pressin
the button .
starts the function.
When the desired value is attained, an
acoustic signal will be emitted.
After the signal, defrosting is
commenced (if such is required based
upon the evaporator sensor's
temperature). Afterwards, the storage
program is switched to.
Manual defrosting of the evaporator
Manual defrosting is only possible as initial defrosting:
Startaprogram:Presson
(waitfor10seconds).
Presson inordertoend/interrupttheprogramagain.Thisthen
causesdefrostingtobecommenced
Do not use pointed or sharp objects to make defrosting go faster!
Automatic defrosting of the evaporator
The unit performs automatic defrosting 1 to 8 times daily, when the "PCL",
"HCL" and "SCL" programs have finished. Defrosting cannot be concluded
manually! In connection with this, the internal temperature inside the unit is
shown before the defrosting process commences.
To Next Page
Loading...
Need help?
General
