114
Propane Systems
Propane System Hoses,
Tubes, Pipes & Fittings
The hoses, pipes, tubes and fittings used in your propane system
are designed to withstand pressures exceeding those of the pro-
pane system. However, because environment and time can both
contribute to the deterioration of these components, they must
be inspected for wear at regular intervals. Be sure to inspect
the hose before each season and when having the tank refilled.
Look for signs of deterioration such as cracks or loss of flexibility.
When replacing the hose or other propane components, always
replace them with components of the same type and rating
(check with your dealer).
Fittings are used to connect the various system components to
each other. The P.O.L. fitting at the end of the propane supply
hose is made of brass so that pipe sealants are not necessary to
prevent leaking. It also has a left-handed thread, which means
that it is turned clockwise to remove, and counter-clockwise
to tighten. The P.O.L. fitting has been designed to help restrict
the flow of LP gas in the event of a regulator failure or hose
malfunction.
Cooking With Propane
Unlike homes, the amount of oxygen supply is limited due to
the size of the RV. Proper ventilation when using the cooking
appliance(s) will help you avoid the danger of asphyxiation.
For additional safety instructions, See p ag e 117, Appliances.
Traveling With Propane
BEFORE towing your RV,
1. ALWAYS check that the propane bottles
are properly fastened in place, and
2. TURN OFF the gas at the LP bottle.
This disables all gas appliances and pilot lights.
DO NOT operate the propane system when the RV is in motion.
• Some states prohibit propane appliances to be operated
during travel (especially in underground tunnels).
• Make sure to know the laws for the areas where you travel.
To Next Page
Loading...