90
Plumbing Systems
Monitor Panel
The monitor panel is found on the interior Command Center.
It displays the fill levels of your fresh water, grey water, and black
water holding tanks. It also shows the voltage of your auxiliary
battery. To make a selection, PRESS and HOLD one of the
labeled buttons on the monitor panel faceplate. Each holding
tank is equipped with a sensor to instantly relay the fill level to
the LED display. See photo (left) & diagram (below)
The monitor panel operates on 12-volt DC power supplied by
either the converter or auxiliary battery. No power is drawn from
the battery unless a button is pushed. Fuses for the monitor
panel are located in the load center.
Operation
Press only one button at a time.
• When the FRESH, BLK, GRY1 or GRY2 button is
pressed, the LED lights display the fill level of the
selected holding tank.
• When the BAT T button is pressed, the LED lights display
the approximate voltage of your auxiliary battery.
TANKS E 1/3 2/3 F
Water pump switch
When the water pump switch is turned ON, the water pump runs
until 45 pounds of pressure has been achieved. Turn the water
pump switch OFF when it is not in use.
Water heater switch
The GAS water heater switch enables propane operation of
the water heater. The ELECTRIC water heater switch enables
electric operation of the water heater.
The red Command Center switches illuminate when
in the ON position.
Monitor Panel
Command Center
Imagine XLS
Command Center
Water Pump & Water Heater
On/Off Switches
Imagine Monitor Panel - LED Indicator Lights
To Next Page
Loading...