7
Plumbing Systems
Furrion Tankless Water Heater
Please read all safety and operating information provided
both here and in the manufacturer’s manual before using
the water heater. Based on the hot water demand, the tankless
water heater will heat incoming cold water to a desired output
temperature by monitoring key sensors to regulate the thermal
energy released over a large heat exchanger. This creates a more
useful and energy ecient heating system versus the conventional
tank water heater that wastes fuel during re-heat cycles and is
limited on volume output.
Controller Operation
Before normal operation of the appliance, perform a basic func-
tional test check out each time the RV and water system is setup
for use. Refer to “Functional Test” of this manual for instruction.
After the Functional test is completed, the appliance can be op-
erated from the wall controller which includes the Power switch.
The control switch can be used for in living “ON/OFF” function.
1. Touch power button
to turn the power ON/OFF.
The Furrion logo on the panel will be illuminated and
display the current temperature setting.
NOTE: The micro processor is always on. It draws approximately
0.25 AMPs, but is advisable to turn o when not in use.
2. Touch button marked “°F/°C” to transform the temperature
display in °F or °C, the related LED would be lighted on the
controller.
3. Touch the
or button to adjust the temperature
to your desired settings. The wall controller settings are
from 95°F (35°C) to 124°F (51°C).
On/Off Switch
Inside the Exterior Door Furrion Tankless Water Heater
Water Heater
Wall Controller
Suffocation
or Fire Hazard
Exhaust gases are hot
and contain carbon
monoxide, do not breathe
or obstruct the exhaust
gases.
Failure to follow this
instruction will lead to
serious injury, property
damage or death.
To Next Page
Loading...
Need help?
General
