Figure 70: Edit Schedule
Enable Non-authorized RFID Card Access Alarm
This option can be enabled from the web GUI, under Alarm Settings → Alarm Event Config
Figure 71: Enable Non-authorized RFID Card Access Alarm
Any illegal card swiped trying to access the door will trigger alarm based on user’s configuration, like below:
Figure 72: Alarm action profile example for illegal card swipe
User will get email, snapshot, etc., based on the Alarm Action Profile configured, to enhance the security of access control.
Alarm Action Settings
This page specifies the configuration of Profile used by the Alarm Actions. A Profile is required before the Alarm Action can
take effect.
Figure 73: Alarm Action
User can edit the alarm action by clicking button, the following window will popup.
Note
This option is configured only on the GDS3705 Model.
To Next Page
Loading...
