Config Server
Username
The username for the HTTP/HTTPS server.
Config Server
Password
The password for the HTTP/HTTPS server.
Always
Authenticate
Before
Challenge
Only applies to HTTP/HTTPS. If enabled, the phone will send credentials before being challenged by the server.
Config File
Prefix
Enables your ITSP to lock configuration updates. If configured, only the configuration file with the matching
encrypted prefix will be downloaded and flashed into the phone.
Config File
Postfix
Enables your ITSP to lock configuration updates. If configured, only the configuration file with the matching
encrypted postfix will be downloaded and flashed into the phone.
Authenticate
Conf File
Authenticates configuration file before acceptance.
XML Config
File Password
The password for encrypting XML configuration file using OpenSSL. This is required for the phone to decrypt the
encrypted XML configuration file.
Provision
Auto Upgrade
Automatic
Upgrade
Enables automatic upgrade and provisioning.
The default setting is “No”.
Start Upgrade
at Random
Time
Configures whether the phone will upgrade automatically at a random time within the configured time interval.
The default setting is “No”
Firmware
Upgrade and
Provisioning
Specifies how firmware upgrading and provisioning request to be sent: Always
Check for New Firmware, Check New Firmware only when F/W pre/suffix
Changes, Always Skip the Firmware Check.
The default setting is “Always Check for New Firmware”.
Firmware
Upgrade
Confirmation
If set to “Yes”, the phone will ask the user to upgrade. If there is no response, the phone will proceed with the upgrade.
If set to “No”, the phone will automatically upgrade without user input.
Default setting is Yes.
DHCP Option
Allow DHCP
Option 43 and
Option 66
Override Server
DHCP option 66 originally was only designed for TFTP server. Later, it was extended to support an HTTP URL. GRP
phones support both TFTP and HTTP server via option 66. Users can also use DHCP option 43 vendor specific option
to do this. DHCP option 43 approach has priorities. The phone is allowed to fall back to the original server path
configured in case the server from option 66 fails. The default setting is “Yes”.
Allow DHCP
Option 120 to
override SIP
Server
Enables DHCP Option 120 from local server to override the SIP Server on the phone. The default setting is “No”.
Additional
Override DHCP
Option
When enabled, users could select Option 150 or Option 160 to override the firmware server instead of using the
configured firmware server path or the server from option 43 and option 66 in the local network. Please note this
option will be effective only when option “Allow DHCP Option 43 and Option 66 to Override Server” is enabled.
To Next Page
Loading...
