P a g e | 71
GRP261x/GRP2624/GRP2634 Administration Guide
Version 1.0.5.48
When there is an active call using headset, press HEADSET button
to hang up the call.
When Speaker/Handset is being used in dialing/talking status, press
HEADSET button to switch to headset. Press it again to hang up the
call. Or press speaker/Handset to switch back to the previous mode.
2. Toggle Headset/Speaker:
When the phone is in idle, press HEADSET button to switch to
Headset mode. The headset icon will display on the left side of the
screen. In this mode, if pressing Speaker button or Line key to off
hook the phone, headset will be used.
When there is an active call, press HEADSET button to toggle
between Headset and Speaker.
Selects whether the connected headset is normal RJ11 headset, Plantronics
EHS headset. Default setting is “Normal”.
Selects normal ringtone or Plantronics EHS ringtone for Plantronics EHS
headset. Default is “Normal”.
Note: It also requires to set "Headset Key Mode" to "Toggle
Headset/Speaker” and manually press the HEADSET button on the keypad
to switch to Headset mode.
Configures to enable or disable the speaker to ring when headset is used on
“Toggle Headset/Speaker” mode.
If set to “Yes, both”, when the phone is in Headset “Toggle
Headset/Speaker” mode, both headset and speaker will ring on
incoming call.
If set to “Yes, speaker only”, when the phone is in Headset “Toggle
Headset/Speaker” mode, only speaker will ring on incoming call.
The default setting is “No”.
Enable EDRC feature, the remote party won't hear the environmental noise
during a call and thus enhance the communication quality.
Configures the transmission gain of the headset.
Available values: -6dB, 0dB or +6dB.The default value is 0dB.
Configures the receiving gain of the headset.
Available values: -6dB, 0dB or +6dB. The default value is 0dB.
Configures the transmission gain of the handset.
Available values: -6dB, 0dB or +6dB. The default value is 0dB.
To Next Page
Loading...
Need help?
General
