GXP1610/GXP1620/GXP1625/GXP1628/GXP1630 User Guide Page 33 of 42
ReConf softkey right after the conference call is split.
Cancel Conference.
If users decides not to conference after establishing the second call, press EndCall softkey instead
of the ConfCall softkey/CONF key;
This will end the second call and the screen will show the first call on hold.
End Conference.
Users could press the EndCall softkey or simply hang up the call to terminate the conference call. If the
remote party hangs up the call itself, it will be disconnected from the conference but other parties on
GXP1610/GXP1620/GXP1625/GXP1628/GXP1630 will stay in the existed conference.
Note:
The party that starts the conference call has to remain in the conference for its entire duration, you can
put the party on mute but it must remain in the conversation.
The option "Disable Conference" has to be set to "No" to establish conference.
When using Easy Conference Mode, use SEND key to dial out the second call instead of using #,
even when # could be used as SEND in normal phone calls.
For 3-ways and 4-ways conference, the host hangs up the phone will end the conference. If users
wants to keep the rest 2 parties stay in conference after the host hangs up ,go to Web GUI- >Account- >
Call Settings > Transfer on conference Hangup, check "Yes" and save the change.
VOICE MESSAGES (MESSAGE WAITING INDICATOR)
A blinking red MWI (Message Waiting Indicator) on the top right corner of the phone indicates a message
is waiting. Dial into the Voicemail box to retrieve the message by entering the voice mail number of the
server or pressing the Voicemail button (Voice Mail User ID has to be properly configured as the voice mail
number under Web GUI->Account x->General Settings). An IVR will prompt the user through the process
of message retrieval.
To Next Page
Loading...
Need help?
General
