GXP17xx Administration Guide
The port for the ACS to connect to the phone.
The Cert File for the phone to connect to the ACS via SSL.
The Cert Key for the phone to connect to the ACS via SSL.
Maintenance Security Settings Security
Configuration via
Keypad Menu
Configures the access control for the users to configure from keypad Menu.
There are three different options. The default setting is “Unrestricted”:
Unrestricted. All the options can be accessed in keypad Menu.
Basic settings only. The SIP option under Phone submenu, and
Network, Upgrade, UCM Detect and Factory Reset options under System
submenu will not be available in LCD Menu.
Constraint Mode. The phone will require administration password to
change the Network, Upgrade and Factory Reset options under System
submenu, and SIP option under Phone submenu as well.
Enable STAR key
Keypad Locking
If set to "Yes", the keypad can be locked by pressing and holding the STAR *
key for about 4 seconds. A lock icon will show indicating the keypad is locked.
The default setting is "Yes".
Note: When the keypad is locked, users would need press and hold the STAR
* key for about 4 seconds again and then enter the password to unlock it.
Configures the password to lock/unlock the keypad.
SSL Certificate used for SIP Transport in TLS/TCP.
SSL Private key used for SIP Transport in TLS/TCP.
SIP TLS Private Key
Password
SSL Private key password used for SIP Transport in TLS/TCP.
Sets the protocol for web interface. The default setting is “HTTP”.
Disables SSH access. The default setting is “No”.
Web/Keypad/Restrict
mode Lockout
Duration
Specifies the time in minutes that the web or LCD login interface will be locked
out to user after five login failures. This lockout time is used for web login, STAR
keypad unlock and LCD restrict mode admin login. Range is 0-60 minutes.
Maintenance Security Settings Trusted CA Certificates
Upload CA Certificate file to phone.
Maintenance Packet Capture
Choose location where the capture will be stored. Default is “Internal Storage”.
Defines whether packet capture file contains RTP or not. Default setting is “No”.