GXP17xx Administration Guide
Network Page Definitions
Table 8: Network Page Definitions
Selects IPv4 Only, IPv6 Only or Both IPv4 and IPv6. Default setting is “IPv4 Only”.
Preferred Internet
Protocol
Selects the preferred internet protocol. By default is “Prefer IPv4”.
Allows users to configure the appropriate network settings on the phone to obtain
IPv4 address from DHCP server.
DHCP Host name
(Option 12)
Specifies the name of the client. This field is optional but may be required by some
Internet Service Providers.
DHCP Vendor Class
ID (Option 60)
Used by clients and servers to exchange vendor class ID. The default setting is
“Grandstream GXP1760” for GXP1760, ”Grandstream GXP1780” for GXP1780,
“Grandstream GXP1782” for GXP1780.
Enter the PPPoE account ID.
Enter the PPPoE Password.
Enter the PPPoE Service Name.
Select to apply the static configuration set for the IP address.
Enter the IP address when static IP is used.
Enter the Subnet Mask when static IP is used for IPv4.
Enter the Default Gateway when static IP is used for IPv4.
Enter the DNS Server 1 when static IP is used for IPv4.
Enter the DNS Server 2 when static IP is used for IPv4.
Enter the Preferred DNS Server for IPv4.
Allows users to configure the appropriate network settings on the phone to obtain
IPv6 address. Users could select “Auto-configured” or “Statically configured” for
the IPv6 address type.
Enter the static IPv6 address when Full Static is used in “Statically configured”
IPv6 address type.
Enter the IPv6 prefix length when Full Static is used in “Statically configured” IPv6
address type.
Select to apply the prefix set on IPv6 Prefix when using “Statically configured” IPv6
address type.
Enter the IPv6 Prefix (64 bits) when Prefix Static is used in “Statically configured”
IPv6 address type.
Enter the DNS Server 1 for IPv6.