4
Grant Euroflame Condensing External Modules
2 - USER INSTRUCTIONS
The boiler is fully automatic once switched on, providing
central heating (and also heating your domestic hot water
if you have a hot water cylinder fitted).
If your system includes a remote programmer, the
boiler will provide hot water and central heating
during the periods set on the programmer.
To gain access to the controls, remove the front panel
by turning the handle and withdrawing it forwards at
the bottom.
Controls for Euroflame Condensing Modules - Fig. A
1 Ensure that - There is sufficient fuel, of the correct
type, in the supply tank and all fuel supply valves are
open. The water supply is on. The electricity supply
to the boiler is off. The room thermostat (if fitted) is
at the desired setting. The boiler thermostat is set to
the required setting (see Section 2.7).
2 Switch on the electricity supply to the boiler.
3 If you have a remote programmer fitted in your
system, refer to the instructions supplied with the
programmer and set the programmer. Set the HW and
CH functions to TIMED. The boiler will now operate
during the 'on' periods set on the programmer.
About your boiler
2.1
Boiler controls (see Fig. A)
2.2
Lighting your boiler (see Fig. A)
2.3
o
C
Overheat thermostat
reset button
(under screw cover)
Boiler thermostat
‘Lock-out’ reset button
Boiler front
panel removed
To Next Page
Loading...
