EasyManua.ls Logo

Grant SAP5 - User Manual

Default Icon
28 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
Loading...
JB Academy, JB Nova and SUB Aqua Pro 31394 V7
Detailed operating manual Page 1
www.grantinstruments.com
Unstirred Water Baths
JB Academy
JB Nova
SUB Aqua Pro
Operating Manual
www.grantinstruments.com
salesdesk@grantinstruments.com
Tel: +44 (0)1763 260811

Table of Contents

Other manuals for Grant SAP5

Questions and Answers

  • J
    Janet FergusonAug 10, 2025
    Why temperature continues to rise when not expected in Grant Laboratory Equipment?
    • X
      xmartinezAug 10, 2025
      If the temperature continues to rise unexpectedly in your Grant Laboratory Equipment, it may be because the set temperature is higher than the liquid temperature. Ensure the bath set temperature is correct. Alternatively, the set temperature might be too close to the ambient temperature. In this case, increase the set temperature, keeping in mind that the minimum temperature should be 5°C above ambient.
  • L
    lisamorrisAug 17, 2025
    How to resolve if temperature does not rise when expected in Grant Laboratory Equipment?
    • A
      Anthony JonesAug 17, 2025
      If the temperature in your Grant Laboratory Equipment isn't rising as expected, the set temperature might be lower than the liquid temperature. Verify that the bath set temperature is correct. Also, if the set temperature is too close to ambient, increase it, noting that the minimum temperature should be 5°C above ambient.
  • M
    Ms. Tanya Garcia DVMAug 25, 2025
    What to do if Grant Laboratory Equipment display shows '????'?
    • A
      Anne BlairAug 26, 2025
      If the Grant Laboratory Equipment display shows '????', it could indicate a faulty temperature probe. A competent person should check the probe for an open or short circuit fault, or contact Grant.
  • T
    Timothy MillerSep 1, 2025
    What to do if the Grant Laboratory Equipment display shows '???'?
    • T
      Tyler SmithSep 1, 2025
      If the Grant Laboratory Equipment display shows '???', it means that the bath is running on its default settings. Contact Grant Instruments' Service Department for assistance.

Summary

Safety Information

Safety Symbols and General Warnings

Explains safety symbols and lists key operational warnings.

Operating Instructions

Operating Procedures

Basic Operation and Water Level Management

Guidance on filling the bath and maintaining optimal water levels.

Dry Start Protection Features

Explanation of the bath's built-in protection against dry running.

Using Heat Transfer Beads

Instructions for using heat transfer beads as an alternative medium.

Using the Water Bath

JB Academy Controls and Temperature Setting

Overview of JB Academy controls, indicators, and how to set the temperature.

SUB Aqua Pro Over Temperature Protection

Setting and understanding the over-temperature protection feature.

SUB Aqua Pro Over Temperature Alarm Setting

Detailed steps to set the over-temperature alarm value.

Calibration Procedures

Configuring Single Point Calibration

Step-by-step instructions for performing single point calibration.

Setting Dual Point Low Calibration

Procedure for setting the low calibration point (LPC).

Setting Dual Point High Calibration

Procedure for setting the high calibration point (HPC).

Technical Specifications

Model Performance Data

Table of specifications for different models, including capacity and current rating.

Warranty Information

Troubleshooting Guide

Common Symptoms and Solutions

Table of common issues, their possible causes, and required actions.

Grant SAP5 Specifications

General IconGeneral
BrandGrant
ModelSAP5
CategoryLaboratory Equipment
LanguageEnglish

Related product manuals