Options: FC5100 Pounce Tool Manual
159
the quality. When you selec a speed that is faster than 60, you cannot select
quality. At that time and “xx” appears.
• Press the F1 key to change FORCE.
• Press the F2 key to change SPEED.
• Press the F4 key to change OFFSET.
• Press the ENTER key to register your setting.
T
O CHANGE THE POUNCE OFFSET
• Press the F4 key to change OFFSET. The blinking cursor indicates that you can
change its setting.
• Press the UP or DOWN ARROW key to raise or lower the numeric value 1-99.
• Press the F1 key to change FORCE.
• Press the F2 key to change SPEED.
• Press the F3 key to change QUALITY.
• Press the ENTER key to register your setting.
NOTE: For the Pounce Condition, the Cutter Offset refers to the spacing between
holes in mm units.
To Next Page
