Grasshopper 600 Series - Lubrication and Maintenance; Capaacitles; Tire Air Pressure Oo; Hydrostatic Transmission 2.0.00

LUBRICATION AND MAINTENANCE
A CAUTION
Always wear safety glasses and ear
protection when performing any
maintenance function that could cause
injury to eyes or ears.
Read all safety information on pages 6 through 9.
A WARNING
Lower attachment to ground, shut off
tractor engine, remove key and wire to
spark plug before performing any
maintenance.
LUBRICATION
Do not let excess grease collect on or around parts,
particularly when operating in sandy areas.
The chart gives the frequency of lubrication in
operating hours based on normal operating condi-
tions. Severe or unusual conditions may require
more frequent lubrication.
Use an SAE multipurpose type grease for all lo-
cations shown. Clean fitting thoroughly before
using grease gun.
For hydrostatic transmissions use Grasshopper
Fluid (Grasshopper part no. 345050 for 1 quart
[.94 1] container).
Lubricate Every Lubricate Every
8 Hours of Usage 80 Hours of Usage
Rear Wheel Bearings Clutch Power Shaft
(one fitting) (two fittings)
Drive Shaft
(onc fitting)
16
CAPACITIES
Fuel Tank oo... ee eeeeeeeecee 4.3 US. gal. (16.31)
Transmission System ........... 3.5 quarts (3.3 1)
TIRE AIR PRESSURE
Drive Tires ......cccccceeeeesseerseeteeneees 8 psi (55 kPa)
Rear Tires ....... 12 to 15 psi (83 to 103 kPa)
HYDROSTATIC TRANSMISSION
Fluid Change 500 hours
Filter Change ..0..0..0ccccceesccecseeseeeeerees 500 hours
CRANKCASE OIL AND AIR FILTER
Refer to the “Engine Manual” for the time table
for changing or service.
COOLING SYSTEM
Inspect the engine cooling fins periodically for
buildup of grass and debris. Buildup on the cool-
ing fins will cause the engine to overheat.
Removal of engine cowling may be required to
clean the fins, especially if cleaned infrequently.
A CAUTION
Do not use high pressure water or steam to
clean the engine or drive compartment.
Water and cleaning detergent may
damage electrical components and
terminals, possibly leading to component
and safety circuit failure.
Use a vacuum cleaner or air blower to remove
foreign material from the engine and drive com-
partment.
Rev. 05-03