www.modellmarkt24.ch; www.modellmarkt24.de
52
SCREEN DISPLAY KEY SETTINGS
MIXER Mixer select 1, 2,....., 4
FROM CHANNEL Signal source / source channel 0,1,2,...6
TO CHANNEL Target channel 0,1,2,...6
TRIM Trim position in % -15 - + 15%
TRAVEL - Travel limit at % Servo travel -150 bis +150%
TRAVEL + Travel limit at % Servo travel -150 bis +150%
Mixer
up to four mixers can be programmed simultaneously. You can switch between Mixer 1, Mixer 2, … and mixer 4 in the
“Mixer” line. The following settings only aect the mixer selected in this line.
From channel
the signal present at the signal source (or source channel) is mixed in to the target channel (TO CHANNEL) to an extent
which can be set by the user. The method of setting up the values is analogous to the “Free mixers” menu in HoTT
transmitters.
To channel
part of the source channel signal (FROM CHANNEL) is mixed into the target channel (TO CHANNEL). The mixer ratio is
determined by the percentage values entered in the “TRAVEL-“ and “TRAVEL+” lines. Select “0” if you do not require
the mixer.
www.modellmarkt24.ch; www.modellmarkt24.de
To Next Page
Loading...
Need help?
General
