www.modellmarkt24.ch; www.modellmarkt24.de
WARNING: if you wish to use this facility, it is essential to observe
the set-up information supplied with the devices connected to the receiver,
otherwise there is a risk that your model may be uncontrollable!
Menu item only at 33579 GR-18 PRO 3XG +3 A + Vario
Telemetry sensor (sensor at K9): This jack allows you to use either for telemetry or for an extra channel (9). (Note: Both
together is not possible!) Switching is done in this menu item. If you select „Yes“, the socket is connected to the connection
of a sensor. If you select „No“ a jack is connected to the control channel 9.
3.3. FREE MIXERS
Important note: If you wish to use the gyros, you must always set the tail
type to ‘normal’ in the transmitter’s model type menu. If your model
is a delta, features a V-tail, or has two elevator servos,
you must use the receiver mixer - not the transmitter mixer - to
control these control surfaces, since the gyro stabilisation system will
have no eect on these servos otherwise.
The four receiver mixers work ‘downstream’ of the gyros. If you have
already programmed mixer functions in the “Wing mixers” or
“Free mixers” menu of your HoTT transmitter, you must ensure
that those mixers do not overlap with those available in this menu!
51
www.modellmarkt24.ch; www.modellmarkt24.de